10KW High Frequency Induction PWHT Machine 380V-460V
Induction heating offers a much faster time to temperature. The
part reaches the desired temperature in a significantly shorter
compared to traditional flame and resistance heating processes,
allowing the job to get done faster.
Induction heating is a much safer heating process as there is no
exposure to open flames or electrical resistance wires and less
exposure to fumes compared to flame heating.
The faster heating time reduces costs due to less labour time, Plus
there is no fuel costs or expensive ongoing inspection or audit
costs associated with the Induction heating process.
Heating is maintained along and through the heat zone by using
induction to heat within the material.
Easy To Set Up
Compared to resistance heating, induction heating is easy to set up
and pull down, making it versatile to go from job to job. Plus, it
the flexibility to fit a variety of pipe diameters and plate
lengths. Various Induction cable configurations can be adapted to
suit your specific application.
In-built diagnostics enables operating parameters to be available
at the touch of a button and offers operator tutoring. On-board
temperature control provides for manual or temperature based
programming in a simple-to-learn operator interface.
Reduce Heating Time by up to 400%
With the Miller Pro-Heat, a part can be brought to temperature in a
faction of the time, compared to traditional flame and resistance
heating processes. It also holds the part at the specified
temperature. It can be programmed to hold and soak for a specified
period of time. Pre-heat time can be reduced by up to 400%. To put
this in perspective, companies using the Pro-Heat have reduced
pre-heating time from over two hours to just 30 minutes.
With the introduction of theInduction Heating Machine, this simple
and cost-effective heating process can be applied in the following
applications to deliver fast and consistent heat:
|Input Amperes at Rated Output||380V-460V,16A|
|Thermal conversion efficiency||More than 90%|
|Maximum Rated output||10KW|
|Cooling Mode||Air cooled|
|Rated Output||9KW at 100% duty cycle,3-35KHZ|
|TC input||2 circuit|
|Control Model||Digital Control|
|Dimensions||H:300MM W:245MM D:550MM|
|Transportation||By sea or By Air|